When receiver is power-off, orange light is blinking within 10s. RF matching light: orange light (B3 IP matching code) When receiver is power-on, orange light is normally on within 10s. Thermostat stop heating until the fault is eliminated. External sensor fault: Light blinks 4 times every 2s Sensor fault : Display "E1" or "E2". No wireless signal within 1h: Light blinks 3 times every 2s 3. IP fault (IP:FFFF) : Light blinks 2 times every 2s 2. Power-on light : green light Load light/fault light : red lightĪWhen no fault: normally on when load output, light off when no load output BWhen fault: blinking 1. Option is automatically recognized and cannot be changed) (when receiver with external sensor, this (When receiver is power-on, press thermostat successively) N1:single built-in sensor N3both built-in sensor and external sensor.
Psg medallion thermostat user manual code#
Follow B05, B06 operation.ī1 IP code low setting B2 IP code high settingĠ0-FF 01-FF Display"55" means IP match successfully. ! Considering battery usage, RF data updates every 20 minutes. After finish setting, standing for 5 seconds ,it will save setting then exit. Power off state, long press for 3-5 seconds to do advanced setting. (anti-freeze protection) display-, cancel anti freeze protectionġ:Open descaling functionFunction works for 3 0ĭisplay A o, long press until show the whole screen When setting temp is higher than 10, screen 5 When setting temp is lower than 35, screen -displays-, cancel highest temp protectionĢ. Switching Differential of External Sensorġ. Switching Differential of Built in Sensor After finish setting, stand for about 5 seconds ,it will save setting then exit.
Psg medallion thermostat user manual manual#
ġ Short press to switch automatic mode and manual modeĢ Power on state, long press for 3-5 seconds to do programmable settingģ Power off state, long press for 3-5 seconds to do advanced setting Īfter finish setting, stand for about 10 seconds ,it will save setting then exit. Pls follow the steps of first time period to set second time period, thirdly time period. press " " and " " to adjust hour, short press " " to confirm then set minutes, press " " and " " to adjust minutes, press " " to confirm then enter into temperature setting, press " " and " " to adjust value. Power on state, long press " " 3-5 seconds to enter into first time period then set hour. Long press " " 3-5 seconds to do Programmable Mode Setting. If you want to close holiday mode, pressĦ times period setting: 5+2 days(factory default),6+1 days, 7 days Then press to switch days and temperature, press, to change value. Power on state, long press for 3-5 seconds to do holiday mode setting. Installation: Wall mounted or on battery seat Running program: Set per 1 week as a cycleĬontact capacity: 5A/250V(WW) 16A/250V(WE) Output: Switch relay (only used for the receiver with external sensor) File Info : application/pdf, 2 Pages, 284.83KB Document Document K1179568555 HY09RF Wireless Thermostat User ManualĢ Auto mode state, press, to enter into temporary manual modeģ Long press to check external sensor temperature